serial port or USB port to change the Ethernet IP port (command: 1F1B1F91004950ip1 ~ ip4).check the USB or serial port for normal communication, if the test is ok, send a command through the.Connect the printer to the computer via the serial port, USB port or Ethernet port, then.There are two other methods for configuring the three printer ports. The first method is as follows: II. Perform customization by sending command codes The self-test page above shows that the new IP address has been successfully set. This method is suitable for all printer Ethernet ports. 4. After the prompt window appears indicating “printer address successfully set”, print the self-test page again to see if the IP address has been changed, as shown in the figure below:.3. Press the “set up IP” button, the computer will wait 10 seconds until a prompt window appears indicating successful configuration. In the process of resetting the IP, the computer will disconnect, and then automatically connect, as shown in the figure below:.2.5. New IP address - Enter the IP address you want to change, click the “set up IP” button to complete the IP setup. 2.4. Printer IP - IP address on the self-test page. (If the local IP and IP addresses of the printer are in the same network segment, the test can be printed by pressing the “connection test” button.2.3. Local IP - IP address of the computer. Click the Refresh button, the IP address of the computer will appear. (Note: if the updated IP address is 0.0.0.0, this means that the local IP is conflicting with other devices and make sure your IP address is unique).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |